Carry Case for FC-12

I'm thinking about getting this one or the black one. I'm planning on using the FC-12 with (2) EV-1's, and would like additional room for anything additional in the future.

https://www.rondomusic.com/product7518.html
pdc410gssl4.jpg

  • Interior length: 29 1/2"
  • Interior width: 15 1/2"
  • Interior depth: 4 3/4" (including the lid)
  • Depth of lid: 1"
  • Weight: 14 pounds
 
Home Skillet said:
I'm thinking about getting this one or the black one. I'm planning on using the FC-12 with (2) EV-1's, and would like additional room for anything additional in the future.

https://www.rondomusic.com/product7518.html
  • Interior length: 29 1/2"
  • Interior width: 15 1/2"
  • Interior depth: 4 3/4" (including the lid)
  • Depth of lid: 1"
  • Weight: 14 pounds
Click to expand...

I have one similar to that, but stopped using it because it just seemed too flimsy. The latches were not very robust, and the hinges on the other side of the lid were too easy to bend. I ended up getting one of these for my MFC-101 and two Mission pedals:

https://www.ebay.com/itm/EFFECTS-PE...-SUPER-SALE-/351229169905?hash=item51c6e3d0f1

Planning to use the same case if I end up getting the FC-6. I'm going to need the 32" version of that case if I get the FC-12.
 
Last edited:
I have been using a dual electric guitar case. One side I put my electric. The other side my FCB1010. Works well. Heavy though. I measured and should work the same for the FC. Then with my Axe III in a 4U rolling rack, I can take everything I need in two cases. One rolls, the other fits like a back pack. This setup of course for local gigs where I don’t have to worry much about how well the stuff is protected. Makes for easy setup and tear down.
 
Rane said:
Zombie thread, but I was literally just debating over that exact soft case on amazon and was worried that it wouldn’t be deep enough. Didn’t realize the sides could come off the FC6. Thanks for posting. 👍🏼
Click to expand...

Your welcome. It flies fantastic:)
 
dfnymusic said:
Has anybody found a case for both the axe fx 3 and the fc12 ? that would be nice to 1 carrying case
Click to expand...
It’s better to have them separate. I have my Axe FX3 in a rack case and I just pull the panels off the front/back instead of taking it out. It protects the unit and also makes it easy to set the unit on its side.
 
You must log in or register to reply here.
Back
Top Bottom