Can't enter a Chan Toggle Custom Label in FC Controller setup

Manny Kuhn

Inspired
Axe FX III Firmware 12.05
Axe-Edit Version 1.05.06
FC-12 Firmware 1.10

The short version:
Setup a switch as Effect -> Chan Toggle
Try to select Custom in the Mini-Display Label pull-down.

The longer version:
I just tried to setup an FC switch for Effect->Chan Toggle in the FC Controller page in Axe-Edit and though the Custom option is visible in the Mini-Display Label pull-down it doesn't quite allow you to select it.

I say 'quite' because, after trying to select Custom, it doesn't show up with a check mark next to it nor does the Custom Label field show as active/editable. However, if I first setup the switch as a different function (e.g. Bypass) and type in a Custom Label then change the Function to Chan Toggle, the previously entered Custom Label shows up on the Switches screen and on the appropriate FC scribble strip but not in the Custom Label field.

In the screenshot below you can see the Mini-Display Label looks like it is set to Current Channel yet it is showing the Custom text on the switch that I had previously entered under the Bypass option. This is after I selected Custom in the Mini-Display pulldown; all the other options work fine.
fc1.JPG
 
Back
Top Bottom