Can somebody double check me - possible bug?

zionplayer

Inspired
I am programming on Layout3, for Layout Link on HOLD press to go to Layout 2. Works properly when I configure it, but it loses the configured setting each time I reboot my Axe-III. I have it working on Layout Link on TAP and it remembers that configuration between reboots.

Tried it from Front Panel and from Axe-Edit - same result.
 
Would you mind sending my the system + global block + FC configurations? That is:
  1. Configure Layout 3 as you would like it.
  2. Backup the System + Global Blocks + FC via Fractal-Bot.
  3. Reboot.
  4. Backup the System + Global Blocks + FC via Fractal-Bot.
Feel free to send them directly to me if you don't want to post to the thread.

Also, what version of firmware are you/were you running on the Axe-Fx III?

Thanks!
 
Would you mind sending my the system + global block + FC configurations? That is:
  1. Configure Layout 3 as you would like it.
  2. Backup the System + Global Blocks + FC via Fractal-Bot.
  3. Reboot.
  4. Backup the System + Global Blocks + FC via Fractal-Bot.
Feel free to send them directly to me if you don't want to post to the thread.

Also, what version of firmware are you/were you running on the Axe-Fx III?

Thanks!

Don't mind posting here, Attaching the backup files requested. As FW 5.02 is out, I loaded that first, rebooted, did my FC configuration and checked that it worked as desired - on Layout 3, switches 1-5 configured so that Switch HOLD would have Layout Link change my FC to Layout 2.

Rebooted Axe-III, configuration for Layout Link on HOLD is empty for switch 1-5 on Layout 3.

190325-175458 backup - after FC Layout Link configuration and testing that it worked, ran backup.
190325-175715 backup - after rebooting Axe-III

FC is on v1.04. Thanks for taking a look! I'll buy you a beer at Axe-Fest.
 

Attachments

  • 190325-175715-system+gb+fc.syx
    192.6 KB · Views: 1
  • 190325-175458-system+gb+fc.syx
    192.6 KB · Views: 1
Back
Top Bottom