Can I use ONLY the Power Amp Sim?

T

Tonemaster

Inspired
I have a Mesa Triaxis that I'd like to use as a preamp. Can I "bypass" the pre amp and only use the power amp sim and effects and take the direct out to the board?. Also, I'd like to place a drive in the loop, preferably before the Triaxis.

Thanks
 
The closest you can get is w/ the jazz or tube pre models set to active tone stack (these have flat eqs), then alter the poweramp section to approximate the power section. This is as close as you can get right now.

It has been on the wish list for quite some time. I would be glad to see it implemented but it doesn't appear it is going to happen.


You can put the drive before and effects after though. See the 4 cable method in the WIKI and/or manual.
 
You must log in or register to reply here.
Back
Top Bottom