Can I rename an IR from Axe Edit?

Not yet but I think so it will.

There is the AxeCabManager made by Cyberferet here at the forum. There are both Mac and Windows version.

Beware though, some users, me included have reported the Axe locking up after the renaming procedure. For me on two different occasions.

It could work for you. You have to try. But if you run into trouble, replace the renamed irs with the original functioning ones.
 
EThe problem is that if your Axe starts to reboot because the ir name was corrupt you could end up in a neverending shut down/restart loop. I solved this by scrolling the big wheel while in start up so that the Axe never "loaded" the preset with a corrupt ir name.
I think you could hold down Recall while turning power on and continue to hold until it finishes booting.
I used the windows version of the AxeCabManager, on Windows 7 64 bit.

Good luck.
 
Wow - Thanks for the advice...
Think I might give that a miss for now.... and wait until Fractal can get it working.
Pauly
 
Back
Top Bottom