Cabs USB Output Blocks

[Jan Geerts]

so, I'm working on this Output 1 to real cabs, Output 4 to PA with cab sim and trying to record on usb.
I've noticed I don't hear cabsims on my usb recordings and I can't find where to assign Output 4 only to usb.
Little help?

 

[sean.e]

Doesn't look like Out 3 or Out 4 are available via USB, only Out 1 and Out 2 are -- from my reading of page 20 in the manual.

 

[Jan Geerts]

Ok, so I need to replace output 4 by 2. But I can't find anywhere how to assign an output to usb, or alternatively mute one.
Is this possible at all? Or is output 1 default usb?

 

[LigLury]

In your DAW you would make the input source as channels 3&4 for output 2. Or I believe you can swap them in Setup>IO>Audio

 

[sean.e]

Out 1 defaults to Computer Inputs 1+2
Out 2 defaults to Computer Inputs 3+4

The defaults can be changed via:
USB OUTPUT MAPPING at SETUP : I/O : Audio

Page 20 in the manual.

 

[Jan Geerts]

Out 1 defaults to Computer Inputs 1+2
Out 2 defaults to Computer Inputs 3+4

The defaults can be changed via:
USB OUTPUT MAPPING at SETUP : I/O : Audio

Page 20 in the manual.

I don't see what the Computer Inputs mean, but I'll check the setup, thanks

 

[SML59]

Please notice that it is not useful to "cable link" OUT 3 and IN 3 in the grid as they must use physical cables, but it's a detail.

 

[Jan Geerts]

Please notice that it is not useful to "cable link" OUT 3 and IN 3 in the grid as they must use physical cables, but it's a detail.

There's a Mel9 in the loop

 

[FractalAudio]

You should use Output 1 for PA/Recording and one of the other outputs for your real cabs.