Cab Block Preamp "High Quality" Mode and Air Parameter - Out of Phase [FIXED]

[GreatGreen]

The title pretty much sums it up. I tried out the new Preamp sims for the Cab block and it sounded fine until I turned on the High Quality mode, then the sound got notchy and out of phase sounding.

I played with other parameters until I got around to the Air control, which I usually leave around 30-40% or so. I dialed it down to zero and immediately the sound filled out nicely again.


I was using the Cab Block in Hi/Ultra-Res mode with the F103: Basketweave TV Mix cab.

 

[kisslorand]

I am not near my AxeFX but I am concerned too if it's true or not. Any "official" input on this?

 

[VegaBaby]

known issue and already fixed for the next update.

 

[kisslorand]

Thank you for letting us know.

 

[yek]

Fixed in 17.02.