Bypass speaker impedance curve?

[luke]

Is there way to bypass this parameter?

 

[shatteredsquare]

On the speaker page, turn LF Resonance down all the way, you can turn down HF Resonance too but that kills everything. Turning the LF Resonance knob down lets you hear it without the BOOOOOOOOOOOOOOOOOOM, let's you tune the breakup right, then mix back in as much low end as you need. LF Resonance is all power amp low end resonance, basically a depth knob in amps that don't have one

 

[FractalAudio]

There's a "Null" curve if that's what you mean.

 

[luke]

There's a "Null" curve if that's what you mean.

Thank you, I suppose so. I did not see it, I will look again.

 

[Bioloop]

There's a "Null" curve if that's what you mean.

Will this give me the curve originally in the axe fx II Xl ?

 

[yyz67]

Will this give me the curve originally in the axe fx II Xl ?

No, if you select it, a flat curve.

 

[shatteredsquare]

AFX2 had an impedance curve but it was generic, still adjustable though. People were asking for impedance curve presets for a while, so in November they put some presets in there for different speaker cab types. If you like the original generic impedance curve from the 2 you could match up the resonance points manually, the effect it has is literally a low boost and a high boost, just like an EQ in the effects loop. Pick the cab that's closest to the cab type of the IR you're using and dial down the LF and HF resonance until it's flat enough for you. If you dial out the HF too much it kind of sounds crap, but LF sounds great all the way down and in between, just like a depth knob.