Vecordia
Member
Ok. I recently got a Seymour Duncan Powerstage 170 to run my Axe Fx III through a 1x12 mesa cab for home practice.
Thing is that I am getting an annoying buzz noise, similar to that when the guitar cable is disconnected from the guitar end.
I go from the output 2L (XLR to TRS cable) into the Powerstage’s input. Then from the Powerstage’out to the cab (8 Ohm).
I have tried the following troubleshooting
However, if i connect the guitar straight into the seymour duncan, (no axe fx) then the noise disappears.
Anyone would know what the problem could be?
I wonder it it could be a problem with the axe
Thanks guys!
Thing is that I am getting an annoying buzz noise, similar to that when the guitar cable is disconnected from the guitar end.
I go from the output 2L (XLR to TRS cable) into the Powerstage’s input. Then from the Powerstage’out to the cab (8 Ohm).
I have tried the following troubleshooting
- Change the output 2 level between +4 dB and -10 dB.
- Change all cables (line, power and amp cable)
- use different wall power outlets (although i had both Powerstage and Axe Fx it connected to the same furman conditioner)
- Lift ground switch at output 2
However, if i connect the guitar straight into the seymour duncan, (no axe fx) then the noise disappears.
Anyone would know what the problem could be?
I wonder it it could be a problem with the axe
Thanks guys!