BUG? - Rate control in the 'Modulation' effects acting weird in AX8-Edit?

Moke

Moke

Axe-Master
Vendor
When attempting to set the 'Rate' control (using AX8-Edit) to 'LFO1 SYNC' in the Chorus, Flanger, Phaser, and Trem blocks, the display knob and/or numbers jump up to some other value depending on the block?

On the hardware it seems okay. Axe-Edit seems okay too.

Also noticed that when I 'double-click' on the 'Flanger' 'Rate' knob, it defaults to '0.250' instead of '1.000' like the others. And the scale is different than the others too, '1.000' is not at '12 o'clock. Was it like this before 9.02?
 
Confirmed. Sort of.

When you dial Rate all the way down, sync with LFO1 still occurs. The number displayed is the actual current rate of LFO1. But you're right: it should still display "LFO1 SYNC" to avoid confusion. (Note that, in 9.03, the Trem block is not affected by this.)
 
You must log in or register to reply here.
Back
Top Bottom