BUG?: MFC-101 Status not updated after EXT(n) switched - Totalsync issue?

plyall

plyall

Power User
I have a patch that uses a Mission SP-1 with the integrated toe switch. I use this switch in a patch to:
  • Turn on the drive
  • Turn on the wah
  • Turn off the Volume Block (using Chris@Katsu's technique), leaving the pedal itself to be used as a Wah controller

When I engage the toe switch, the drive LED (IA#7 in my case) on my MFC-101 stays red (indicating not engaged).

Could the MFC-101 code either be tweaked to watch the controller pass-through data, or under other circumstances poll the Axe-FX II to get a status update after an EXTnn is sent?

Thanks!
 
not a bug, rather a limitation.
pretty sure this can't happen currently with external switches. probably a hardware issue?
 
You must log in or register to reply here.
Back
Top Bottom