BUG? - FAS-FX Reverb - Panning question - not stereo?

MisterE

Fractal Fanatic
I was experimenting with the Reverb in Reaper and I noticed that however I set the panning in the send, the Reverb remained stereo.
I have 2 guitar tracks 1 panned hard left and 1 right.
So I wanted to fool around with the panning of the reverb of those tracks.
If I pan the send of the Left Guitar, it doesn't do much until I cross the center and pan it right, then it dies out.
Same for the Right Guitar channel.
I compared this to the ReaVerb and there I can pan the individual reverbs by using the send in the routing.
So I assume that the Fas-Fx Reverb isn't processing in stereo but summing, as in the AxeFx III.
 
Thanks Alexander.
But I can't seem to get it to work as described when using send.
Routing:
Routing.jpg

Reverb:
Reverb.JPG

As you can see, the reverb isn't panned left.
Maybe I'm doing something wrong?
 
On the Config page of the reverb, check INPUT SOURCE.
Pasting from the manual:

CONFIG PAGE
INPUT SOURCE – The input source mode control determines if incoming signals will be processed in stereo
or summed to mono before reverb processing.
 
Back
Top Bottom