darko89
Member
Hello everyone!
I am having some issues with modifiers and midi messages.
So the scenario is the following:
I have a preset where I would like a midi message to toggle the Input boost, fat switch, and bright switch at the same time. I am setting the midi message to be 49 on the MIDI I/O external menu. I am sending from a Morningstar MC6II the midi message with a value of 127 and 0.
The issue occurs when I try to map the modifiers. As I start adding the modifiers it completely loses sound. If I save the preset with the modifiers set, the FM3 loses sound maybe 3-4 seconds after a restart. Only when removing these modifiers the FM3 ( after a restart ) starts to work again.
I have attached a preset ( you probably have to change cabs to make it work ) and some screenshots.
The signal chain goes through a Strymon Bigsky in the "loop".
I tried to reproduce it with a preset from scratch with only an amp, cab, and nothing in the loop ( so straight to output 1 ) and the issue wasn't there. Maybe I am doing something wrong?
Running FM3 Edit 1.01.06 and Firmware 1.05. I don't think it's related to FM3 Edit because the problem occurs even when closing FM3 edit and restarting the FM3 unit.
Edit:
I also doubt it's the Strymon getting maybe a midi message because the Strymon is getting messages on channel 2
I am having some issues with modifiers and midi messages.
So the scenario is the following:
I have a preset where I would like a midi message to toggle the Input boost, fat switch, and bright switch at the same time. I am setting the midi message to be 49 on the MIDI I/O external menu. I am sending from a Morningstar MC6II the midi message with a value of 127 and 0.
The issue occurs when I try to map the modifiers. As I start adding the modifiers it completely loses sound. If I save the preset with the modifiers set, the FM3 loses sound maybe 3-4 seconds after a restart. Only when removing these modifiers the FM3 ( after a restart ) starts to work again.
I have attached a preset ( you probably have to change cabs to make it work ) and some screenshots.
The signal chain goes through a Strymon Bigsky in the "loop".
I tried to reproduce it with a preset from scratch with only an amp, cab, and nothing in the loop ( so straight to output 1 ) and the issue wasn't there. Maybe I am doing something wrong?
Running FM3 Edit 1.01.06 and Firmware 1.05. I don't think it's related to FM3 Edit because the problem occurs even when closing FM3 edit and restarting the FM3 unit.
Edit:
I also doubt it's the Strymon getting maybe a midi message because the Strymon is getting messages on channel 2
Attachments
Last edited:
