[Bug] Axe Edit 3.9.0 moving shunts

F

FirstMM

Member
Has anyone else spotted this happening...?
If I grab a shunt and move it, another shunt appears in the first available slot (going left to right and top to bottom)

Is this just me?
 
Michael Pickens said:
Good catch. I'll add this fix to the next release.
Click to expand...
Hi, Michael.

I have observed a peculiar behaviour about the shunt as well in the AX8 edit.
I do not see the option to remove a shunt and replace it with an empty block.
So for example, if I create a shunt in a parallel path which diverges from the cab and then later decide that I don't want the parallel path, I do not see the option to simply remove the shunt and make that block empty again. If you're not responsible for the AX8 edit, can you ask someone from that team to look into it? Would be very much appreciated.

Thanks!
 
Bhargav Sarma said:
Hi, Michael.

I have observed a peculiar behaviour about the shunt as well in the AX8 edit.
I do not see the option to remove a shunt and replace it with an empty block.
So for example, if I create a shunt in a parallel path which diverges from the cab and then later decide that I don't want the parallel path, I do not see the option to simply remove the shunt and make that block empty again. If you're not responsible for the AX8 edit, can you ask someone from that team to look into it? Would be very much appreciated.

Thanks!
Click to expand...
Delete the block.
 
You must log in or register to reply here.
Back
Top Bottom