yyz67
Fractal Fanatic
On 12.11, when changing or sweeping Screen Frequency from max down to min (1.00) using the front panel Value knob, my axe crashes (loud thump and Out 1 meters pegged). It is somewhat intermittent with Screen Q set at default but almost guaranteed with Screen Q at the minimum (0.1). Attached is minimal preset that does it.
I understand if this is a "Cliff says: 'don't do that!'" scenario but just letting FAS know in case there is something else going on internally (like NaN).
If anyone would like to confirm (on 12.11 or latest FW) with the preset here: turn OUT 1 down and don't have your monitors on to save them from the thump. Turning the Value knob quickly to max and back to min will likely cause the out 1 meters to go red.
I understand if this is a "Cliff says: 'don't do that!'" scenario but just letting FAS know in case there is something else going on internally (like NaN).
If anyone would like to confirm (on 12.11 or latest FW) with the preset here: turn OUT 1 down and don't have your monitors on to save them from the thump. Turning the Value knob quickly to max and back to min will likely cause the out 1 meters to go red.
