1. We would like to remind our members that this is a privately owned, run and supported forum. You are here at the invitation and discretion of the owners. As such, rules and standards of conduct will be applied that help keep this forum functioning as the owners desire. These include, but are not limited to, removing content and even access to the forum.

    Please give yourself a refresher on the forum rules you agreed to follow when you signed up.
    Dismiss Notice

Boost from Amp

Discussion in 'FX8 Discussion' started by catscanman82, Jun 30, 2017.

  1. catscanman82

    catscanman82
    Expand Collapse
    Inspired

    Joined:
    Oct 3, 2014
    Messages:
    108
    Likes Received:
    28
    i have a new Badger 18 with the built in boost mode and wondering if I can control it from the FX8 and if I can how to set it up. Thanks for the help in advance.
     
  2. joe rogers

    joe rogers
    Expand Collapse
    Forum Addict

    Joined:
    Oct 9, 2014
    Messages:
    1,556
    Likes Received:
    2,769
    I would reach out to Suhr. The FX8 relay outputs employ a "Short-to-Sleeve" connection. Each relay output can short Tip-to-Sleeve, Ring-to-Sleeve, and Both. If you give this information to Suhr, they should be able to tell you if this is compatible with the boost pedal input. Please note: if the pedal connection uses a voltage drop to power an LED, the relay circuit on the FX8 is rated for a maximum of 200mA.
     
  3. catscanman82

    catscanman82
    Expand Collapse
    Inspired

    Joined:
    Oct 3, 2014
    Messages:
    108
    Likes Received:
    28
    Thanks Joe for your help.
     

Share This Page