Block MFC bank from going lower than 0

H

Harm

Experienced
Hi all,

For a while when I pressed " bank down" it didn't go under the first bank. I had to press up to go to the highest bank. That was excellent. I must have changed something, because now, when I press "down" after the first bank it goes to the highest preset bank.

Any way to block it again? Would be nice to just keep it pressed on stage knowing that when I release it I'll be back at presets 1-5.

Thanks, Harm
 
Just to be sure...
There is NO "Bank 0" with my MFC MKIII.

Are you sure you don't mean "Bank 1"?

I use Banks of 10 Presets.
Do you do something different that allows for labeling the lowest bank number "Bank 0"?
If so, I'd like to know how that's done.
 
joegold said:
Just to be sure...
There is NO "Bank 0" with my MFC MKIII.

Are you sure you don't mean "Bank 1"?

I use Banks of 10 Presets.
Do you do something different that allows for labeling the lowest bank number "Bank 0"?
If so, I'd like to know how that's done.
Click to expand...

Hi! Yeah, sorry, I was at work so I guessed the number. Fortunately Yek got what I meant. It is 1. And it took me 5 minutes to fix this. Now I can press “ bank down” as much as I want to, but it stops at 1 and doesn’t go from 1 down to the highest number 78? Something?) the only way now to het to the highest bank is by going up (or the front panel of the axe)
 
You must log in or register to reply here.
Back
Top Bottom