Best input impedance ideas??

Panthersn

Member
I'm just finishing up the mock up stage for two custom guitars, one has active Seymour Duality and the other TV Jones Setzer. I'm using 59 Bassguy 001 patch and my input imped is set to auto but its clipping just ever so slightly, you can really notice when you dig in with a pick. I would like to leave in auto so switching guitars wont require two patches or scenes. Any config ideas? The TV Jones are low output.

IMG_2094.jpg
 
Input impedance is not related to your issue, as far as I am aware.

When you say "clipping", what do you mean?

Most likely you are wanting to adjust the Input Level, which is for the A/D converters. The guideline is to set that relative to the hottest pickups, and so it occasionally "tickles the red".

If instead, by "clipping" you mean overdriving the amp... Well, that is the nature of high vs low output pickups.
 
... my input imped is set to auto but its clipping just ever so slightly, you can really notice when you dig in with a pick. I would like to leave in auto so switching guitars wont require two patches or scenes.
View attachment 46069
This is not about input impedance but input level.
Page to the Input page of the I/O menu under SETUP.
Reduce Input 1/Instrument input levels using the A knob.
 
This is not about input impedance but input level.
Page to the Input page of the I/O menu under SETUP.
Reduce Input 1/Instrument input levels using the A knob.

trying it now. I thought there was an auto Imp like on my old Eleven Rack
 
Back
Top Bottom