Neumann1970
New Member
Well hello fractal forum!
On fcb 1010 I am using sw1 or sw2 port with mono jack out , and in fender port FTSW, after connect and teaching( push and flashing save button ) led near FTSW didn't change colour during one footswitch button shake and nothing occure( no reaction ) . Is there compatibility between those devices ?
Programming switch settings:
1. Power
2. Set presset (in my case 1(one))
3. Direct select (1(0))
4. Press DOWN 2-3 seconds
5. Active sw1 and sw2 - leds are red
6. UP/ENTER - for commit
7. DOWN - exit
What's wrong ? How can active controll on fcb 1010?
Thank you
On fcb 1010 I am using sw1 or sw2 port with mono jack out , and in fender port FTSW, after connect and teaching( push and flashing save button ) led near FTSW didn't change colour during one footswitch button shake and nothing occure( no reaction ) . Is there compatibility between those devices ?
Programming switch settings:
1. Power
2. Set presset (in my case 1(one))
3. Direct select (1(0))
4. Press DOWN 2-3 seconds
5. Active sw1 and sw2 - leds are red
6. UP/ENTER - for commit
7. DOWN - exit
What's wrong ? How can active controll on fcb 1010?
Thank you