AxeFX II XL + MFC-101 Mk III + Axe-Edit 3.x

[Sleestak]

Greetings. Apologies if this has been covered elsewhere. I did look and couldn't find a definitive answer.

When I'm preparing to run my Axe FXII XL with Axe-Edit 3.x, is there any need to power down and disconnect my MFC-101 Mk III first? I know Axe-Edit takes control over the AxeFX for communication, and changes may not be reflected on the MFC. What I'm wondering if there is a problem leaving it connected / powered up while I'm using Axe-Edit.

 

[ocaptainjr2]

I always leave it connected and have never had an issue going back to the days of owning an Ultra and then a II and now an XL. The only time you should disconnect the MFC is when updating firmware.