Axe II and Matrix GT1000FX = GREAT !!!

[mrpollack]

Only a question.. why would you connect the out 2 of the AXE to the Matrix?

Cause when you you use in your chain FX Loop send, the sound before Cab simulation goes to out 2 as it should

 

[cellopet]

So if I use only Axe Fx II, Matrix Gt1000Fx And My cab, i must use the Out 1, as always...

 

[paulmapp8306]

No. You CAN, but dont have to.

Personally, I run all my FX, then take a branch off to the FX loop, which sends the signal to OP 2, the Matrix and my cab. After the branch I add a cab block, and a PEQ which then goes to OP 1 and FOH (for when needed). I only do this as OP 1 has XLR outs which is better for FOH.

the only thing there is you cant any FX post cab block, or they wont be present in you one stage amp/cab sound. I can live with that.