Just_Kidding_Studio
New Member
Signal flow- Axe ultra v11 -> presonus 16.0.2 midi I/O -> PC
I've checked the firmware. I have the most current drivers for my presonus, I have the MIDI cables hooked up properly. I have the midi control turned to 'on' in my presonus board.
I checked the forums for my specific board and I couldn't find anything. Seeing if someone here might have had a similar issue.
sends and received midi, I followed all of the steps in the manual
sends midi info from axe edit, BPM info. But when I add stuff in an block, like a pedal, it crashes.
syncs with axe fx ultra preset data from the box, but crashes after any edit.
Once it crashes I have to uninstall and reinstall again for it to even go into axe edit.
I tried using older versions from the legacy page with the same result.
Send help
I've checked the firmware. I have the most current drivers for my presonus, I have the MIDI cables hooked up properly. I have the midi control turned to 'on' in my presonus board.
I checked the forums for my specific board and I couldn't find anything. Seeing if someone here might have had a similar issue.
sends and received midi, I followed all of the steps in the manual
sends midi info from axe edit, BPM info. But when I add stuff in an block, like a pedal, it crashes.
syncs with axe fx ultra preset data from the box, but crashes after any edit.
Once it crashes I have to uninstall and reinstall again for it to even go into axe edit.
I tried using older versions from the legacy page with the same result.
Send help