'Axe-FX Name Timeout!'

Radley

Experienced
'Axe-FX Name Timeout!' I keep seeing this on my MFC since I updated to the latest firmware, and the preset names are no longer shown on the MFC readout - any ideas what could be causing this?

Thanks!
 
I had this with the previous version. I loaded 2.02 and have not seen it.
This should probably be listed in the MFC Forum.
 
it's been awhile since i've seen this, but iirc, it has to do with the MFC mode. meaning AXE II, Ultra, ect.
 
Make sure is it set to EXPANSION and AXE II.

Edit > MIDI > Use Port Expansion
&
Edit > Setup > Axe -Fx Mode II
 
Make sure is it set to EXPANSION and AXE II.

Edit > MIDI > Use Port Expansion
&
Edit > Setup > Axe -Fx Mode II

Thanks - That fixed it! Apparently my previous settings were lost when I installed the new firmware...
 
It didnt solve my MFC-101 arrived yesterday. is it poor quality connectors?

1. What Firmware does it have?
If it's not 2.02, then upgrade first.
2. What are you using to connect it to the AxeFX-II?
The quality of cable used won't matter much since MIDI is digital and interference can be filtered out.
 
Back
Top Bottom