thehydeout
Experienced
Hey, I just started with this app and MFC so still finding my way around, but when I open a file I get the warning "NOTE: In this mode the "Axe-FX Func" column on the IA switches page is ignored". This is because it is set to "None". If I set it to XL+ and save the file, when I reopen it I get the same error and it's set back to None.
Why does it not save this setting in the SysEx file?
I found this also gets transmitted to the MFC so if I don't remember to change it in the editor every time I send a file I have to go into the settings on the MFC and change it back.
(Note, I just installed the software and do not even have the key for it yet if that makes a difference)
Thanks
Why does it not save this setting in the SysEx file?
I found this also gets transmitted to the MFC so if I don't remember to change it in the editor every time I send a file I have to go into the settings on the MFC and change it back.
(Note, I just installed the software and do not even have the key for it yet if that makes a difference)
Thanks