UAD API channel strip, $249 https://www.uaudio.com/uad-plugins/channel-strips/api-vision-channel-strip.htmlAPI channel strip??
3333.- Euro
That’s a killer interface btw.Simply plug the line outs from the Axe (Output 1) into the two inputs of the Twin. Set Output 1 control to full (unity gain). Set the volume for monitoring to your liking on the mixer desk in the Console application. In your DAW, select the Twin as your interface and use its analog inputs 1-2 as input sources to record the processed signal of the Axe Fx.
That's all.
That’s a killer interface btw.
you have the ultimate set-up
https://www.sweetwater.com/store/de...VAobICh3nRQHBEAAYASAAEgJ1dfD_BwE&gclsrc=aw.dsSadly, I have to say goodbye to it, soon. Need a computer upgrade and the new Macs don't have Thunderbolt 2 connectors anymore.
Well, that means I will probably simply swap it out for an Apollo Twin X. ;-)
yep, Axe out 1 - Apollo mic pre's sounds great.
I got a SPDIF -> Optical converter to run mine which makes all the cabling cleaner and easier to record in stereo, but also frees up the mic pre's in the Apollo should I want to utilise them
Do you need to clock them? I’m about to try this exact setup.not in the axe fx. you'll need to change the apollo hardware setting, so that the digital input is spdif and the sample rate is 48k.
Hi Simon, just found your message after days used to experiment recording FX via Apollo TWIN x (connected via SPDIF). In my case the OUT1 control knob on FX front panel doesn’t modify the volume , is’t normal/correct? I’m using the Apollo out monitorok, so plug the axe into the little box with the spdif cable and then plug the little box into the apollo with the adat/lightpipe cable
open up apollo console (the mixer app thingy that comes with it) and click on "settings" in the bottom left hand corner
select the "hardware"tab and you'll see "digital input". make sure that's set to "spdif" and "sample rate" is set to "48kz" and clock source is set to whichever one gives you a lock (can't remember which is the one to select, i suspect "internal")
on the axe itself, you'll just need to check in I/O that spdif/aes select = spdif and spdif out source = output 1
yes, that's correct.the OUT1 control knob on FX front panel doesn’t modify the volume , is’t normal/correct? I’m using the Apollo out monitor