Hello guys..
Searched on the forum about the issue I am having but can't find the right thread.
I was using XLR output of my Axe Fx III for recording mainly. But just wanted to try the SPDIF output lately. However, I can't hear anything (no input signal on UAD console) from either my monitor or Logic and get it work as it should be.
This is my setting and how I hook up the unit.
Axe Fx III SPDIF output to RCA/Toslink convertor
Toslink Cable output to Apollo Twin SPDIF Input
(The convertor should work because when I touch the RCA plug, the meter on my UAD Console is moving)
Axe FX III I/O setting
Apollo Twin UAD Console
DAW: Logic
I got 2 Axe FX III for testing and the same issue occur, So I believe it must be my wrong setting in I/O rather than hardware issue.
Can anyone help
Thanks!!
Searched on the forum about the issue I am having but can't find the right thread.
I was using XLR output of my Axe Fx III for recording mainly. But just wanted to try the SPDIF output lately. However, I can't hear anything (no input signal on UAD console) from either my monitor or Logic and get it work as it should be.
This is my setting and how I hook up the unit.
Axe Fx III SPDIF output to RCA/Toslink convertor
Toslink Cable output to Apollo Twin SPDIF Input
(The convertor should work because when I touch the RCA plug, the meter on my UAD Console is moving)
Axe FX III I/O setting
- World Clock: SPDIF/AES IN
- SPDIF/AES Select: SPDIF
- SPDIF/AES Out Source: INPUT 1
- Input 1 Config: Analog
Apollo Twin UAD Console
- Sample rate 48khz
- Clock: S/PDIF (If I set the Clock as "Internal", there is huge noise from the monitor)
- S/PDIF L/R input is 9/10
DAW: Logic
- Buffer size set to 256
- Input set for 9-10
I got 2 Axe FX III for testing and the same issue occur, So I believe it must be my wrong setting in I/O rather than hardware issue.
Can anyone help
Thanks!!