Axe-Fx III routing question

[gdgross]

Hi all -

However, I was perusing the AxeIII manual and couldn't find the following information:

I understand the headphone output is always connected to output 1/2. What I couldn't find in the manual was how the metronome could be routed.

I'd like to be able to create a preset that uses a looper block with quantization ON, (ie, loop slaved to the tempo) and a metronome out separate from the main audio out. Can this be done in the AXEIII?

I would be happy to grab an isolated metronome out from any available output and use any of the others for the main audio signal. If I have to pan hard L/R on some block to achieve this, that's ok too.

(for the record, I'm not an ax3 owner, but patiently waiting for an FM3.)

Thanks!

 

[unix-guy]

I am pretty sure that's in there now but the manual hasn’t been updated in a while.

 

[gdgross]

I am pretty sure that's in there now but the manual hasn’t been updated in a while.

Thanks - so the metronome can be routed to, or mixed into, any of the output blocks (ie, is it a separate block?) in the axeII/8, you just turn it on and get it everywhere.

 

[DLC86]

Yes it can be done, the metronome has independent level controls for out1, out2 and spdif/aes out

 

[gdgross]

Yes it can be done, the metronome has independent level controls for out1, out2 and spdif/aes out

Perfect!