The new negative feedback values will load when selecting an existing preset. [...] the parameter value will be reset to the default value upon preset load.
I'm sure that's, "The new negative feedback values will load when selecting an existing preset... for the first time the... after this firmware is applied... but just the once"I'm confused. Is this an internal value or is in the value on the user-controlled negative feedback parameter (dial)?
If every time a preset loads the user negative feedback parameter value is set back to the default, then am I correct there is no way to change the value and save it without the value resetting?
I think presets contain the info on which firmware they were last saved/created, so i assume those parameters reset every time you load a preset saved on a previous firmware.I'm sure that's, "The new negative feedback values will load when selecting an existing preset... for the first time the... after this firmware is applied... but just the once"
Like, rust, Cliff never sleeps.Cliff..do you ever sleep?!? Appreciate your dedication and artistry.
Just me or is it a bit brighter than 8?
New parameters don't typically show up in Axe Edit until a new version is created, adding the new parameter(s). This usually happens once the Beta version is stable and the final Firmware version is released.Hello!
Speaker Impedance - I can't find it.
Where is?
This ^^^^.New parameters don't typically show up in Axe Edit until a new version is created, adding the new parameter(s). This usually happens once the Beta version is stable and the final Firmware version is released.
Thanks!New parameters don't typically show up in Axe Edit until a new version is created, adding the new parameter(s). This usually happens once the Beta version is stable and the final Firmware version is released.
Thanks dear Yek !Yes, there seems to be a bit more (very pleasing) high content. Firmware sounds excellent.