My question as well.Question on the global setting -
I've been running the Beta and have tweaked some of my presets to use curves which I like, will these presets be impacted if 'Yes' is chosen (because they're not the current version) - or will they be left alone as they're already 11?
Right, also The Cabinet Resonance parameter that can be used to adjust the amount of cabinet resonance in the impedance curve is on the Speaker Page.Is there a reason for the Speaker Impedance Curve parameter to only reside on the Advanced page? It seems like it would make sense for this to be accessible from the Speaker page where you could actually see the graph for the curves as you scroll through them instead of having to page back and forth between Speaker and Advanced. I know this goes against the tweak with your ears, not eyes mantra but I think it would be more convenient.
I would think they would only be impacted if they've been changed from the default selection when selecting an amp.Question on the global setting -
I've been running the Beta and have tweaked some of my presets to use curves which I like, will these presets be impacted if 'Yes' is chosen (because they're not the current version) - or will they be left alone as they're already 11?
The name doesn't fit.Is there a reason for the Speaker Impedance Curve parameter to only reside on the Advanced page? It seems like it would make sense for this to be accessible from the Speaker page where you could actually see the graph for the curves as you scroll through them instead of having to page back and forth between Speaker and Advanced. I know this goes against the tweak with your ears, not eyes mantra but I think it would be more convenient.
How about Spkr Imp )The name doesn't fit.
I would think they would only be impacted if they've been changed from the default selection when selecting an amp.
SIC Parameter?The name doesn't fit.
That's exactly what I am wondering. I very rarely use 4x12 irs so pretty much any amp that would default to a 4x12 impedance curve has been changed to a non default curve. I'm hoping I don't have to re-do all the presets I have changed form the default curve.I would think they would only be impacted if they've been changed from the default selection when selecting an amp.
LOL, as a developer I can sympathize. It'd be awesome if you could cram it in there somehow.The name doesn't fit.
No room. The value will be cut off and people will then complain they can't see the full name of the impedance model.LOL, as a developer I can sympathize. It'd be awesome if you could cram it in there somehow.
How about Spkr Imp )
Is the former 11.00b behavior maintained WRT switching the SIC wiping the old curve out of NULL and making NULL flat like a resistor?Yeah
Axe-Fx III Firmware Release Notes
11.00
Amp block now uses new high-order speaker impedance modeling. 50 speaker impedance models (and two LB-2 models) are included and can be selected using the Speaker Impedance Curve parameter (on the Advanced page). Selecting an amp model will load an appropriate default Speaker Impedance Curve for that amp model. The Cabinet Resonance parameter can be used to adjust the amount of cabinet resonance in the impedance curve.
Setting Global “Update Pre-11.x Presets Spkr Imp Upon Load" parameter to YES will automatically update the Speaker Impedance Curve for the Amp blocks upon preset recall to use an appropriate Speaker Impedance Curve for that amp model. Setting the parameter to NO will leave existing presets unaffected. NOTE: Setting this to YES will also cause the EDITED LED to light indicating the preset has been modified.
Fixed Recto1/2 models default Negative Feedback and Power Tube Bias values slightly too low.
Fixed loss of precision in Drive block Tone control for some models (Rat, Timothy, et. al.) causing low frequency build-up over time.