Axe-Fx III Firmware Release Version 14.00

Status
Not open for further replies.

FractalAudio

Administrator
Fractal Audio Systems
Moderator
www.fractalaudio.com/downloads/firmware-presets/axe-fx-3/14p0/axefxiii_dsp_rel_14p00.zip


Axe-Fx III Firmware Release Notes


14.00

Improved Amp block cathode follower accuracy. The Hardness parameter has been removed and the default values have been changed. Existing presets are automatically updated. If you have edited the cathode follower parameters you should audition your presets as these parameters will automatically be reset to default values when the preset is loaded.

Because of the cathode follower change the following amp models have been updated:
Friedman Small Box
Dizzy V4 Blue (all models)
Herbie (all models)
Recto 1/2 (all models)

Due to the discovery of a measurement error the JMPre-1 models have been completely reworked. If you are using any of these models it is recommended to reset the block and audition your preset(s).

The Tube Pre model has been changed so that the power amp is off by default.

Added a couple new amp models.

Fixed turning Diffusion Time all the way up in Delay block causes noise.

Fixed ADSR graph goes funky if Attack time is set very low and other times are relatively large.

Fixed knob labels for sliders not centered under sliders if number of sliders is less than 5.
 
You need to hunt for them.
Here we all go, off to the hunt....
easteregg.gif
 
Status
Not open for further replies.
Back
Top Bottom