DLC86
Fractal Fanatic
Would it be possible to increase the range? With some amps (e.g. Hiwatt) I have to set it to 10 to barely get 1dB of compressionYeah, I find I'm dialing in between 2 and 4 as well. Sometimes even higher.
Would it be possible to increase the range? With some amps (e.g. Hiwatt) I have to set it to 10 to barely get 1dB of compressionYeah, I find I'm dialing in between 2 and 4 as well. Sometimes even higher.
Would it be possible to increase the range? With some amps (e.g. Hiwatt) I have to set it to 10 to barely get 1dB of compression
Sure that would work, but I don't want to increase MV, it's already in my sweet spotIncrease MV.
Looks like I didn’t have to hold out on the unlucky 12.13 for long
You were smart to skip that one. Most of us now have inoperable brain tumors.
Available in FracPad (free on desktops)Thanks, I do that, I'd just prefer a one-button compare function, like synths (at least used to) have.
As it is, I end up with a bunch of copies with different name variations, which I then have to go back through, reconstruct what I was thinking, figure out if it's an improvement, a cool new thing, or trash.
One button please.
Compression models the reduction in volume as the voice coil heats up.Speaker compression sounds really nice on sparkly cleans too.
I just reread the blocks guide about Speaker Compression, Compliance, and Drive. As I understand it, each is effectively speaker compression with different (potentially tasty) artifacts.
@FractalAudio, can you compare and contrast Compression, Compliance, and Drive? Do they capture independent factors or if one of these parameters is turned up high the others should be turned down or off? I know we can "use our ears" but curious...
The default used to be 2.0. I reduced it to 1.0 because I felt it was better to be conservative with the default value and let people increase it if desired. I'm considering increasing the default back to 2.0 (or higher).Sort of a philosophical question - if you're finding this parameter sounds better in this range, would you ever change the default setting to line up with what you think sounds better? Or is the default value of 1 closer to the actual "real world" amplifier, and as such, is something that you wouldn't adjust in a future firmware release?
I'm considering increasing the default back to 2.0 (or higher).
What's the first rule of wanting help?I'm finding I have a lag between scene switches when using the Brit Pre and the Shiva Clean amps.
I have done the "refresh after firmware" AND tried closing Axe Edit, still lag...only going from the Brit pre to the Shiva, going from Shiva to Brit Pre does NOT have the lag. Never had this before 12.14.
I can revert, haven't tried it yet, however would prefer to resolve.
Any thoughts...??
Not sure how to upload the preset.
Using FC12 for switching.
What's the first rule of wanting help?
Buy you a sammich? No, wait, that's my rule.What's the first rule of wanting help?