thud_peterson
Inspired
Compression sounds really good. Tried Marshalls on and off and noticed the growl. Never used speaker compression before but using from now on.
Speaker compression changes, eh? Noice noice.
Hope this translates well to real cabs!
Since this is simulating real speaker behavior I suspect you wouldn't use it with real cabs...I hope it will translate to real cabs better than it is now.
I really miss that open sound of an amp and cab that growls in distortion
I thought so too before, but apparently that's not true.Since this is simulating real speaker behavior I suspect you wouldn't use it with real cabs...
Interesting...I thought so too before, but apparently that's not true.
http://forum.fractalaudio.com/threa...2-00-public-beta-2.144615/page-2#post-1710669
Speaker compression changes, eh? Noice noice.
Hope this translates well to real cabs!
When initializing the amp block, Negative Feedback has the correct default value 2, but when double click on the knob in Axe III Edit, it reverted back to the previous/wrong default value 3.5.
This might be a general issue for double click in Axe III. Here are my questions:
1. Why is the double click revert to a different default value? What does that default value mean v.s. amp's initial default value? Is that just an random value? Then the double click is broken...
2. How do I revert to the correct default value, e.g. the same as when initializing the amp block?
3. How do I revert to the default value when working with the Axe III unit alone without the Axe Edit?
Thanks!
“If using a solid-state amp into a traditional cab I would recommend Speaker Compression and Compliance not be zero." https://forum.fractalaudio.com/threads/axe-fx-iii-firmware-2-00-public-beta-2.144615/post-1710669
How are you guys setting speaker compression? (I know use your ears, just wanna hear some others findings)
All the amps default at 1.00 @ 100 ms, but this can't be right since every amp should be different, or am I misunderstanding?
When initializing the amp block, Negative Feedback has the correct default value 2, but when double click on the knob in Axe III Edit, it reverted back to the previous/wrong default value 3.5.