Hi
@clags:
Go to the 30 minute mark in this LiveGold Video tutorial and watch for five minutes. The readme notes also explain it all. Same concepts apply to Naked Amps TonePack as well.
If you don't have an FC12 or FC6 foot controller, and you just use the editor to make your sounds, then here's the work around: go to CONTROLLERS, and then to "CS Per Scene" page, to decide whether you want to turn an CS (Control switch) from CS1 to CS6 in any given scene. My presets just use CS2 to CS6.
***Note, if you make a change in say Scene 2 to turn CS2 ON from that CS per Scene page, and go back to Scene 2, the editor's view/GUI may not show the change yet (Amp Boost switch may look off). You may have to switch to a different scene and then back to Scene 2 for the GUI of editor to "catch up" and show your CS2 change made in the Controllers area.
You CANNOT toggle/move the CS switches assigned to amp boost, cut, fat, etc. on the Amp Page itself - this drives some people crazy, but it makes sense because they are tied to modifiers. So, instead you turn them on/off in the CONTROLLERS area of the editor.
I keep meaning to get a specific video out on this, in fact did a draft one this weekend but not happy with it and will re-shoot that and post here once done.
CS2 - turns on amp BOOST
CS3 - turns on Amp FAT
CS4 - reverses the default bright switch. If Amp model default to brite on, this turns it off, and vice versa
CS5 - turns on IDEAL saturation
CS6 turns on or reverses the low CUT