Axe-Fx II Firmware 19.00 Public Beta #3

FractalAudio

FractalAudio

Administrator
Fractal Audio Systems
Moderator
Thanks for making this your passion Fractal! It is my honor to support and enjoy your efforts!
 
Tusen takk :)

waynes-world_Excellent.jpg
 
FractalAudio said:
This is close to a release version. The only difference may be that some factory cabs are replaced by IRs that we will be capturing in the studio this week.

Mark I/II:
www.fractalaudio.com/downloads/firmware-presets/axe-fx-2/19.0/axefx2_19p00beta3.zip

XL:
www.fractalaudio.com/downloads/firmware-presets/axe-fx-2/19.0/axefx2_xl_19p00beta3.zip

XL+:
www.fractalaudio.com/downloads/firmware-presets/axe-fx-2/19.0/axefx2_xlplus_19p00beta3.zip
Click to expand...

Thank you for your hard working and keep the Axe-Fx update and fresh.
 
*******************************************************************************

Release notes 19.00

Improved many of the Drive models by applying “G3” techniques. Note that this
may cause significant changes to the behavior of some models. Of particular
note is that the taper of the Drive and Level controls has changed in many of
the models and may differ substantially from previous firmware. Models that have been fully converted to G3 models are indicated in the name.

Added a new Clip Type to the Drive block. The “Variable” type allows the user
to adjust the shape of the clipping using the new “Clip Shape” parameter. Low
values of Clip Shape give a smooth, focused tone while high values give a
harder, brasher sound.

Improved Cabinet block Motor Drive algorith. The new algorithm more accurately
models power compression.

Improved Amp block power tube plate current calculation. This results in
increased clarity, improved feel/attack and better edge of breakup distortion
texture. The default Power Tube Bias values have been updated to reflect this
change and existing presets will be updated automatically to the new values.

Changed all references to “CK” in the Cab block to “ML”.

The Output Compressor in the Amp block now features two modes of operation:
Output and Feedback. These modes are set using the new Comp Type parameter.

“Output” is the previous type where the compressor acts on the output of the
block. “Feedback” also compresses the block output but applies dynamics to the
input of the block based on the output compression. The “Comp Clarity”
parameter adjusts the bass response of the input dynamics and can be used to add
clarity to the bass.

Added EQ Location parameter to Amp block. The sets the position of the graphic
EQ. The default value of “Post P.A.” places the EQ at the output of the power
amp. “Pre P.A.” places the EQ between the preamp and power amp.

Increased the maximum Drive available in the Delay block. This allows adding
distortion to the echoes when using the Delay block before an Amp block.

Existing presets will automatically be updated to reduce the Drive accordingly.

Increased the maximum Drive available in the Multi-Delay block. This allows
adding distortion to the echoes when using the Multi-Delay block before an Amp
block. Existing presets will automatically be updated to reduce the Drive
accordingly.

Increased Frequency Multiplier range in Ring Modulator block to 0.25-4.0.

Existing presets using the Ring Mod should be auditioned to ensure proper
operation.

“G3'd” the Citrus A30 amp models.

Improved detector performance in Multiband Compressor.

Improved detector performance in Compressor block Dynamics mode.

Fixed “Thordendal” amp models referencing wrong default tone stack.
 
You must log in or register to reply here.
Back
Top Bottom