Axe-Fx II "Ares" Rev 1.01 Firmware Release

Status
Not open for further replies.
Thank you Cliff!!!

Axe-Fx II Firmware Release Notes:
*******************************************************************************
Ares 1.01
Ported most of the “Ares” modeling from the Axe-Fx III. NOTE: To make space for the required additional code, support for presets created prior to Quantum 7.00 has been removed. While these presets will load certain parameters may not initialize correctly. Be sure to audition any presets created before Quantum7.00. It is also recommended to do a “soft reset” of the Amp block on these presets by deselecting and then reselecting the model.

*******************************************************************************
Ares 1.00
This firmware is a partial port of the “Ares” modeling used in the Axe-Fx III. Not all aspects of the Ares modeling were able to be ported but the most important parts were and the amp modeling should sound very similar.

*******************************************************************************
10.01
Fixed background tone in some amp models due to uninitialized variable.
Fixed Friedman 2018 amp model bug.
Added Plexi 2204 amp model.
*******************************************************************************
 
Last edited:
I'm curious to see if Cliff managed to squeeze the new Cathode Follower algo into this FW... :smirk:
 
Last edited:
Ported most of the “Ares” modeling from the Axe-Fx III.
Can we get more specific info?...

Anyway, I am blown away by this support.
Thank you for everything.
Can people expect an update for AX8, or will it not fit?
Also, really hope the "Axe Edit" dev guys can place their final nail.
 
Last edited by a moderator:
That’s two new firmware updates for a discontinued product. I mean, where else are you going to see that?
 
Status
Not open for further replies.
Back
Top Bottom