Axe-Fx II and FCB1010: MIDI offset problem!

soundroi

Member
Hi, I'm using an Axe FX II XL+ with a FCB1010 controller. Everything is working but every program change I send from the FCB1010 is understood a - 1 by the Axe. So if I send PC 12 from the controller, the Axe goes to preset 11, while I have selected "from 12 to 12" in custom mapping.
Display Offset and Midi Offset are at 0 in the I/O menu.
Midi offset does not work in custom mapping.
I understand that the PC values in the Axe are 0-127, while in the FCB1010 are 1-128.
So how do other FCB1010 users deal with this?
Thanks in advance,
Roi.
 
Display offset at 1 will make the Recall menu preset numbers match the FCB.

There isn't a way to make the custom map parameters start at 1, so you'll just need to remember that when adjusting those settings.

Another possible solution would be to increase each FCB preset's PC value by 1, leaving display offset at 0.
 
You can but if I remember well, must not use display offset in FCB AND axe fx ii. Just try different settings with ripwerkx and you'll get it working...it worked out for me as long as I used the FCB.
 
Back
Top Bottom