buro
New Member
HI folks !
I bought a older Axe Standard which was never updated - current FW version is 5.24.
I tried to update a FW but I still have a problem with Axe edit - It doesn´t recognize the Axe device. I´m using a TIE 1i1o Midi interface (I tryied also a few different types... buit there was the same problem)
I already tried:
More Axe edit versions - Axe-Edit Beta 1.0.191 and older, without any successful results
Change of IN/OUTs in (in the each AXE Edit version) no improvement... The only success was once when I used "THRU" instead of "OUT" - the MIDI loopback test passed, but Axe edit was still not able to recognize my device.
Is there any specific setting which should be set (In axe edit or on the unit) ? Sysex ID is set on Unit and in Axe edit on 125. Is there anything else, what should be set?
Many thanks for any advice which allows me to update a FW...
Thanks.
Maros
I bought a older Axe Standard which was never updated - current FW version is 5.24.
I tried to update a FW but I still have a problem with Axe edit - It doesn´t recognize the Axe device. I´m using a TIE 1i1o Midi interface (I tryied also a few different types... buit there was the same problem)
I already tried:
More Axe edit versions - Axe-Edit Beta 1.0.191 and older, without any successful results
Change of IN/OUTs in (in the each AXE Edit version) no improvement... The only success was once when I used "THRU" instead of "OUT" - the MIDI loopback test passed, but Axe edit was still not able to recognize my device.
Is there any specific setting which should be set (In axe edit or on the unit) ? Sysex ID is set on Unit and in Axe edit on 125. Is there anything else, what should be set?
Many thanks for any advice which allows me to update a FW...
Thanks.
Maros