Could it be the reason for the minimum value? Don't see how setting something outside of the range of a parameter can be considered a bug.When I try to set the “Screen Frequency“ control on the amp power supply page to a value lower than the minimum (in this case “0”), I get a loud pop, the output meters go to max, and the output signal (at least on my headphones) goes to zero. I have verified this by creating a new preset with just an in, out, and amp block (default 59 bassguy).
I can’t make this happen with just the mouse. I have to type in the too-low value.
Axe fx 3 version 11.01. Axe Edit 3 version 1.3.10.
Apologies if this has already been reported or if this is not the right place to report it.
Setting something outside the range should not be allowed - that's the point of a rangeCould it be the reason for the minimum value? Don't see how setting something outside of the range of a parameter can be considered a bug.
Setting something outside the range should not be allowed - that's the point of a range
Yes, but the "Authentic" page is blank, currently. To adjust the bass corner frequency, use the bass knob on the "Ideal" page.Im a bit confused ..... not at my Axe 3 at the moment ..... does the new DC 30 EF 86 Amp Channel show up in the current [ 1.03.10 ] version of Axe Edit (?)
Thanks,
Ben