Axe Edit doesn't follow MFC buttons?

[Rexgtr]

I have an Axf Fx II mk I and a MFC-101 mk I

I'm noticing for example when I step on an effect Axe Edit doesn't indicate that the block(s) are bypassed or on?
Is this normal with Axe Edit 3.14.3? It used to work fine.

btw, recently I needed to use MIDI Out of the MFC into the Axe's MIDI In
(because I bent the pins of my Expansion Ethernet connector)
I'm on Firmware Quantum 10.0.1 and mfc-101 3.08

 

[iaresee]

Never has. You can use one or the other but not both at the same time. Pause Axe-Edit, use the MFC, un-pause Axe-Edit and it'll re-sync itself to the current state of the unit.