AX8 with a line out for just the looper

[jrgg]

Hello.
I need to send just the output of what I play into the looper,(not what I play over it), to another musicians monitor.
Can anyone suggest the way to achieve this? Maybe with the Fx loop in the AX-8? I use both XLR outs in stereo so those are tied up.

Thanks.
Jim

 

[ChristThePhone]

Put the loop block in parallel to the normal signal chain, turn it's mix to 100%, then send its output into the FX loop. This way the loop will be audible only via the FX send, not via the XLR outputs. It also means there will be no signal on FX send until the loop playback starts.

 

[jrgg]

Thanks. Much appreciated! This is what I needed to know.