Ax8 reamping

[edo]

I’m finally working on my commercial U2 preset packs for the ax8. I have the di recordings of the sample clips I made with the axe fx2, and would like to know how to reamp those tracks with the ax8, so I can have the same clip / take reamped in both fas units.

Thanks in advance!

 

[Smittefar]

It is a little cumbersome on the AX8 compared to the AxeFX2

You have to run an analog out from your audio interface into the FX loop return (level set to +4 dBu), and then return from the AX8 main out to your audio interface. There are a few really long threads about the minor nitty-gritty details.

Here are two threads
https://forum.fractalaudio.com/threads/reamping-adds-major-noise-whats-wrong-solved.121320/

https://forum.fractalaudio.com/threads/ax8-di-recording-question-solved.119558/

Specifically this post https://forum.fractalaudio.com/thre...whats-wrong-solved.121320/page-3#post-1449670

 

[edo]

It is a little cumbersome on the AX8 compared to the AxeFX2

You have to run an analog out from your audio interface into the FX loop return (level set to +4 dBu), and then return from the AX8 main out to your audio interface. There are a few really long threads about the minor nitty-gritty details.

Here are two threads
https://forum.fractalaudio.com/threads/reamping-adds-major-noise-whats-wrong-solved.121320/

https://forum.fractalaudio.com/threads/ax8-di-recording-question-solved.119558/

Specifically this post https://forum.fractalaudio.com/thre...whats-wrong-solved.121320/page-3#post-1449670

Thank you, will have a look at these threads