AX8 Edit Software Info To AX8 Hardware

Carsonics

New Member
Is there a way to transfer the info on the AX8 Edit Software screen to the AX8 Hardware screen? The hardware just shows blank blocks even though the preset in the software has been saved. Is there a way to transfer the software screen info to the hardware screen? I can't figure out how to do that and there's no info in the manual about it. Yes they are probably connected by USB from the AX8 to computer.
 
Click Footswitches in Edit and assign blocks to be controlled by the footswitches.

If you page over to Layout on the hardware, you’ll see the blocks as they are in Edit.

Your AX8 screen is blank because there are no footswitches assignments. The blocks are there in Layout.
 
Back
Top Bottom