Hi Guys:
Had a little time today and so under firmware 14 I started to reset and updates the amps Cliff listed in the release notes that were affected.
When I got to the
Diezel Herbie Channel 3 preset for the LIVEGOLD Axe-Fx III (and FM3) TonePack, I found an error (by me).
I did not set the Saturation or Amp Boost values in all four channels. This is very bad if you hit the CS5 switch - it will clip.
The fix is very easy:
In the Amp Block for the Herbie 3 preset, under the IDEAL tab, go to the right and where is says SATURATION DRIVE, change the value from 4.0 to 1.1. You need to do this for all four channels - ABCD. Make sure after you do it, before you save, that the amp channel matches the scene (1= Amp A, 2 = Amp B, 3 = Amp C, and 4 = Amp D).
Then, still on the AMP block page, on the Preamp tab, where it says BOOST LEVEL on right side, change the value from 12db (default to 8 db (or whatever sounds good to you). Do the same thing for all ABCD amp channels. Again, Make sure after you do it, before you save, that the amp channel matches the scene (1= Amp A, 2 = Amp B, 3 = Amp C, and 4 = Amp D).
Save and it's fixed. Whenever there is an update released later (probably; with new firmware) this will be fixed, but you can do it yourself now.
Thanks guys! Rock on. I LOVE this Herbie 3 Amp channel - the "Sometimes Salvation" Scene 1 is based off the sound of the Black Crowes song of the same name.