Assigning Master Layout Menu to external switch

Enzee

Member
Hi guys,

I've read the FC manual (pg 32 to be specific), but for the life of me can't seem to figure out how to configure and trigger the MLM from an external switch.

The setup:

I am running two FC-6s connected to my III. I have a Mission TT-2 dual switch connected via a TRS cable to FC-6 #2 switch 1/2. Switch #2 of the TT-2 (right side) is programmed to trigger the tuner and works perfectly. I am trying to figure out how to get switch 1 to trigger the MLM on FC-6 #2.

Would anyone be so kind as to maybe step me through this? I know this must be incredibly easy.

I can't thank you enough.
 
I'm not sure this is possible.

I don't recall seeing an option to reassign the MLM.

If you could, you'd need to use Stand-in switch functionality.
 
When I go into Settings>Stand In Switches I can go to FC 2 SW 1 and assign any of the 8 layouts to SW 1 and that works perfectly. However, there is no selection for the Master Layout Menu which is what I need. Any thoughts?
 
You have to configure a switch (as normal) for Master Layout. Then assign that switch as the stand-in for your external switch and you should be good to go.
 
Back
Top Bottom