Assignable USB Computer Input sources

AlbertA

AlbertA

Fractal Fanatic
Currently, the USB Inputs are hardwired:
  • 1+2 source is Output 1 block
  • 3+4 source is Output 2 block
  • 5+6 source is Input 1
  • 7+8 source is Input 2
It would be great to have options in the Setup->I/O->Audio tab to assign sources to USB inputs.

Something like:

USB Configuration
1+2 Source: <option>
3+4 Source: <option>
5+6 Source: <option>
7+8 Source: <option>

Where <option> can be any of: OUT1, OUT2, OUT3, OUT4, Input1, Input 2, Input 3, Input 4

If not possible or too extensive, I would like at least an option for 7+8 source to be assignable to Input 3/Input 4. This part was already implemented :)
 
Last edited:
+1
This is a really good idea! That would be the little change that would make the axe fx III easier to use as a multipurpose audio interface I think.
 
Just wandering ,How difficult , such a procedure would be ,to route and implement ?
Is it more of a hardware or software technicality ?
 
You must log in or register to reply here.
Back
Top Bottom