I recently went with Synergy for my main tones, and plan to use the AX8 for FX only via 4CM and as an emergency backup if the main rig has any issues (with copies of all my patches in a separate bank, loaded with amp/cab, etc).
Anyone here using a similar setup? My question is in how to perform the channel switching. If I understand correctly, the AX8 can send MIDI messages per scene, so I want to set up several scenes per patch that will switch channels on the Synergy as needed (the channel switching on it is MIDI). I really only need to switch between 2 modules, and not different channels per module, as all of my modules are single channel anyway.
Curious if anyone here has any tips or tricks on how to set this up? I'm not very MIDI-knowledgeable but I'm going to experiment with it tonight and see what happens.
Any insight would be most appreciated!
Anyone here using a similar setup? My question is in how to perform the channel switching. If I understand correctly, the AX8 can send MIDI messages per scene, so I want to set up several scenes per patch that will switch channels on the Synergy as needed (the channel switching on it is MIDI). I really only need to switch between 2 modules, and not different channels per module, as all of my modules are single channel anyway.
Curious if anyone here has any tips or tricks on how to set this up? I'm not very MIDI-knowledgeable but I'm going to experiment with it tonight and see what happens.
Any insight would be most appreciated!