Chuk
Inspired
I've just received my AxeFXIII and I'm setting up the Liquid Foot Pro (the original series not the + series) to connect.
I copied all my midi settings from my AxeFxII across into the AxeFxIII.
The Fractal settings mostly ported straight across but there are a couple of variations.
I haven't been able to get the SCENE CHANGE settings to work properly on the AxeFXIII when using the LF Pro. They work perfectly on the AxeFxII.
The SCENE SELECT (CC34) & SCENE INC/DEC (CC 126/124) are the same in both units yet the Scenes change as per usual in the AxeFX2 but act strangely in the AxeFX3.
I only setup four scenes in the LFPro (on S7,S8,S9,S10).
When I change a patch all the default red leds activate in the appropriate locations/pedals. When I push a scene change button (S7-10) the AxeFX3 changes to the appropriate scene but the whole foot controller 'locks up' for seven (7) seconds exactly. I timed it over and over again. After seven seconds all the default red leds go out leaving the selected Scene Change button as the only light on the board. Each time, after seconds has elapsed, the LF Pro becomes functional again until the next scene change.
When I plug in my AxeFX2 everything works as it should.
There must be a 'rogue' setting I guess. Do you know what could be causing this?
Has anyone had a similar experience?
I copied all my midi settings from my AxeFxII across into the AxeFxIII.
The Fractal settings mostly ported straight across but there are a couple of variations.
I haven't been able to get the SCENE CHANGE settings to work properly on the AxeFXIII when using the LF Pro. They work perfectly on the AxeFxII.
The SCENE SELECT (CC34) & SCENE INC/DEC (CC 126/124) are the same in both units yet the Scenes change as per usual in the AxeFX2 but act strangely in the AxeFX3.
I only setup four scenes in the LFPro (on S7,S8,S9,S10).
When I change a patch all the default red leds activate in the appropriate locations/pedals. When I push a scene change button (S7-10) the AxeFX3 changes to the appropriate scene but the whole foot controller 'locks up' for seven (7) seconds exactly. I timed it over and over again. After seven seconds all the default red leds go out leaving the selected Scene Change button as the only light on the board. Each time, after seconds has elapsed, the LF Pro becomes functional again until the next scene change.
When I plug in my AxeFX2 everything works as it should.
There must be a 'rogue' setting I guess. Do you know what could be causing this?
Has anyone had a similar experience?
Last edited: