Another looper question Mark II

M

Mark's Tone

Power User
Long time listener, first time caller.

Just got my new toy's yesterday. Havn't slept much. :|

Is there a factory preset number that has the looper function already set up using the FC101?

I have been all over looking for an answer, and I just want to play.

If not, would one be so kind as to give me a 123 step primer on how to insert properly and correctly using the front panel? And the adjustments required on the FC.

Or a source that describes the steps?

Kindest Regards to all you dudes.
 
To insert a block of any kind, navigate to the preset you want to edit. Press LAYOUT. Use the NAV buttons to move the cursor to where you want to insert or replace a block on the grid.
Turn the VALUE wheel (big wheel) to select the type of block you want and press ENTER to insert it on the grid. In this case you will be adding a LOOPER block. After you place the block, you
can then press the EDIT button to set the looper up how you like.
Hope that helps. And welcome to the forums.
 
You must log in or register to reply here.
Back
Top Bottom