Amp & Cab Quick Reference Guide updated

[kmanick]

awesome thanks

 

[MrGuitarabuse]

Awesome!!! thanks

 

[DTS]

Give this man a medal! Great work! Thank you!

 

[SarasotaSwing]

You are on the ball! Thanks again!

 

[jma]

Updated for v13/Axe-Edit 3.0.4. :joyous:

 

[rodzimguitar68]

Updated for v13/Axe-Edit 3.0.4. :joyous:

13.01 though, right?


EDIT: 13.02 was just released, so now 13.02 is the latest iteration.

 

[Neilius]

Many thanks for this, sir!

 

[jma]

Updated for firmware v15, Axe-edit 3.0.10. 8)

 

[psycle_1]

Updated for firmware v15, Axe-edit 3.0.10. 8)

Thank you for this! Awesome work sir!

 

[floydrose]

Very good !!!

Too bad there is no translation in French

 

[AlGrenadine]

great !
Thanks jma

 

[yek]

Great job!

I added more links to your guide in the wiki.

BTW, Modeling Modes have been reduced in fw 15.

 

[cobbler]

Updated for firmware v15, Axe-edit 3.0.10. 8)

Well done. What a great resource! Thank you for all the hard work. :encouragement:

 

[Coby]

Thank you!
But just a question: anyone has idea of what cab is the 4X12 Lerxst and with what speaker's loaded?

 

[yek]

See List of Cabs in the wiki.

Ported cab with greenbacks, meant to be used with Marshall Silver Jubilee.

 

[jma]

BTW, Modeling Modes have been reduced in fw 15.

Thanks, Yek. Axe-Edit 3.0.10 still shows the Grid Cond Off option, though it no longer exists on the front panel. I added cab descriptions for the new factory IRs. To everyone: with all the changes in the last few dot updates, some parameter descriptions and highlights may no longer be accurate. PM any suggestions/corrections.

 

[jandjrs]

]Thanks jma!

 

[vestapol]

Thanks man!

 

[yek]

Thanks, Yek. Axe-Edit 3.0.10 still shows the Grid Cond Off option, though it no longer exists on the front panel. I added cab descriptions for the new factory IRs. To everyone: with all the changes in the last few dot updates, some parameter descriptions and highlights may no longer be accurate. PM any suggestions/corrections.

Not seeing Grid Cond in AE here. Where do you see it?

 

[jma]

Not seeing Grid Cond in AE here. Where do you see it?

Other page > Modeling Mode drop menu.