Bug? All lights red after failed? FW update, unit locked

[Mikael65]

After I tried to updated FW on my MFC-101 Mk III the unit is locked and all lights are red. Display blank.
Does not matter if I use power adapter och Cat 5 cable.

Tried the reset I found in the instruction (holding down #11 at power up).

Has anyone had the same experience? Any ideas what I could try?


Regards
Mikael

 

[maxdown]

Have you tried installing the update again using the 'ADVANCED: Power via Ethernet/EtherCon or FASLINK' instructions in the Firmware Update Guide pdf in the update folder? Can you get the MFC into FW Receive mode when holding down Switch #1 when booting it by turning on the Axe-FX while in that Cat5 and MIDI cable setup?